Utility Function; Utility Execution - Mitsubishi Electric GOT2000 Series User Manual

9. UTILITY FUNCTION

Utility is a function, which carries out connection of GOT and controller, screen display and operation method settings,
program/data control and self-check etc.
9.1

Utility Execution

For utility execution, utility has to be displayed by installing BootOS and package data in the C drive (built in flash memory).
(BootOS is installed in the GOT at factory shipment. It is not necessary to install BootOS when upgrading of it is
unnecessary.)
There are following two methods for installing BootOS and package data.
1) GT Designer3 → GOT
GT Designer3
2) GT Designer3 → SD card → GOT
package data
GT Designer3
Refer to the following for the installation which uses GT Designer3.
➠ GT Designer3 (GOT2000) Help
For the installation methods of package data with an SD card, refer to the following.
➠
18. BOOTOS AND SYSTEM APPLICATION INSTALLATION USING DATA STORAGE
Via a USB interface or
Ethernet interface
Installing BootOS
or package data
Writing Installing
package data
Install an SD card
SD card
to the GOT.
• Install directly from GT Designer3
GOT
• When the GOT is located in a remote place,
GOT
package data can be easily installed with a
SD card.
9.1 Utility Execution
9
9 - 1