Mitsubishi Electric GOT2000 Series User Manual page 626

18.3.1 Installing when starting the GOT
■1. When installing with an SD card
Step 1.
Power OFF the GOT, and install the SD card where the BootOS, system application or project data is stored
in the SD card interface of the GOT.
Step 2.
Power on the GOT.
While touching the lower right side of the GOT screen, power on the GOT. (1-point press installation
function)
Step 3.
The BootOS or system application is installed in the built-in flash memory.
Do not pull out the SD card or power OFF the GOT.
Step 4.
The GOT restarts automatically after the installation is completed.
Step 5.
After confirming normal restart, confirm that the SD card access LED is not lit, and remove the SD card from
the SD card interface of the GOT.
18.3.2 Installing using the data copy function (Utility)
■1. Operation procedure
Step 1.
Power OFF the GOT, and attach the SD card which stores the basic system application and communication
driver to the GOT.
Step 2.
While touching the upper left corner of the GOT screen, power ON the GOT.
Step 3.
When the screen shown on the left appears, select the [Data copy].
For details of install, refer to the following.
➠
18 - 4
18.3 BOOTOS AND SYSTEM APPLICATION INSTALLATION USING DATA STORAGE
15.7 Data Copy
Touch
[Data copy].