Mitsubishi Electric GOT2000 Series User Manual page 99

Step 4.
If touch the [OK] button, the changed settings are reflected and the screen returns to the [Communication
setting] screen.
If touch the [Cancel] button, the changed settings are canceled and the screen returns to the
[Communication setting] screen.
Step 5.
In the [Communication setting] screen, touching the [OK]/[Cancel]/[×] button restarts and operates the GOT
with the changed settings.
■2. Channel-Driver assign operation
The following describes how to operate the Channel-Driver assign.
The following description uses an example of changing the serial communication connection to the direct CPU
connection by changing the communication driver from [AJ71QC24, MELDAS C6*] to [Serial(MELSEC)].
Step 1.
IInstall the communication driver [Serial(MELSEC)] to the GOT.
(Download of [Controller Setting] from GT Designer3 is not required.)
After installing communication driver, touch the [Channel Driver assign] button in [Channel-Driver Assign].
Step 2.
Touch the [Change assignment] button on the displayed screen as shown below.
POINT POINT POINT
Before the operation
The GOT automatically restarts after executing this setting.
If project data has been downloaded, the GOT starts monitoring of the controller after restarting.
Execute this setting after carefully confirming the safety.
2 - 55
2.10 Controller
2