Error Display - Mitsubishi Electric GOT2000 Series User Manual

For details of error messages, refer to the following.
➠ ■1.
When only the project data was copied to the GOT, touch the [ESC] button to restart the GOT and display
the user-created screen.
When the basic system application was copied, the GOT will automatically start up and display the user-
created screen.
(If the project data does not exist, a message appears to notify that the project data does not exist.)
■1. Error display
When copying is not available between the GOT and the memory card, check the following contents according to the
GOT error display.
No memory card is installed.
The model information does not match.
The write protection switch of the SD card is ON.
No data to be a copy target exists in the copy source.
Please check source and destination.
15 - 46
15.7 Data Copy

Error display

POINT POINT POINT
(1) When installing or removing an SD card
Always set [Permissions] on the GOT. For details, refer to the following.
➠
15.4 SD Card Access
(2) Removing the USB drive
The USB device should be in the removable status. For the setting method, refer to the
following.
➠
15.9 USB Device Management (GT2107-W)
Error message
Install an memory card to the GOT.
The model set for the data in the SD card does not match with that of the
copy target GOT.
Use the same model data as that of the copy target GOT.
The write protection switch of the SD card is ON.
Turn off the write protection switch.
There is no data to be a copy target in the copy source.
Store the data to be copied in the copy source and copy it again.
The combination of your copy source and copy destination is not correct.
Change settings to correct the combination of your copy source and
copy destination.
Remedy