Sequence Program Monitor
Sequence program monitor setting
Storage locations and others for data to be used for the sequence program monitor function can be set.
Storing a sequence program eliminates the need for reading the program from the PLC CPU at the next GOT startup. This
shortens the time required for the execution of the sequence program monitor.
For the details of the sequence program monitor, refer to the following.
Data save location
Select the storage location for the sequence program monitor.
Select whether to automatically read sequence programs when the sequence
Automatic program read
program monitor starts from a touch switch or alarm display.
If both Common comment and Each program comment are set for the same
device in a sequence program, select either of the comments to be displayed in
the sequence program monitor.
Select whether to enable or disable the ladder editor of sequence programs
Ladder editor (R ladder)
(MELSEC iQ-R series).
■1. Sequence program to be saved
The sequence program to be saved is used by the GOT to execute the sequence program monitor.
The sequence program can be saved in the SD card with this function, however it cannot be copied in the personal
computer to be referred/edited with GX Developer, etc.
3 - 8
3.3 Sequence Program Monitor
GOT2000 Series User's Manual (Monitor)
A: Built-in SD card
B: USB Drive
E: USB Drive
F: USB Drive
G: USB Drive
<Default: A: Built-in SD card>
Common comment/Each program comment
<Default: Common comment>