Installing Using The Data Control Function (Utility) - Mitsubishi Electric GOT2000 Series User Manual

7.3.2

Installing using the data control function (Utility)

For details of data control function, refer to the following.
➠ 6. DATA CONTROL
■1. Operation procedure
(1) When installing with an SD card
Step 1.
Install the SD card where the BootOS, system application or project data is stored in the SD card interface
of the GOT.
Step 2.
Close the cover of the SD card interface of the GOT.
Step 3.
Display the data control function screen (Utility) on the GOT, and install BootOS, system application from
the SD card to GOT.
Step 4.
The SD card access LED is lit during the install execution.
Do not pull out the SD card or open the SD card interface while the SD card access card is lit.
Step 5.
GOT restarts automatically after installation is completed.
Step 6.
After confirming normal restart, confirm that the SD card access LED is not lit, and remove the SD card
from the SD card interface of the GOT.
POINT POINT POINT
Precautions on executing data control function
When execute data control function, system application has to be installed in GOT in advance.
Thus, this function cannot be used for the initial installation of BootOS, system application after
purchasing GOT.
Install system application by the following two methods.
• GT Designer3
• Installing when starting the GOT
Now installing BootOS.
Reboot.
7.3 BootOS and System Application Installation Using Data Storage
Touch [Install]
7
7 - 7