Broadcasting the clock data
Notify the clock data of the GOT to the controller for synchronization with the GOT.
The following explanation uses GT2104-R as an example.
■1. Time notification setting
Broadcast CH No.
Time zone of target unit
Time difference from GMT
If [Broadcast the clock data] is deselected or [Trigger Type] is set to [Sampling] in [GOT Setup] in the project data, only [Sampling]
is selectable as the trigger type for the time notification in the utility.
If [Broadcast the clock data] is deselected or [Trigger Type] is set to [Sampling] in [GOT Setup] in the project data, [No setting] is
displayed for the device.
Switch the Use/Disuse of Broadcast.
Set a channel used for the time notification.
Set the trigger type for the time notification.
• When selecting [Sampling] for [Trigger type], set the sampling interval for
the time notification.
• When selecting [Rise] or [Fall] for [Trigger type], information on the device
set as a trigger is displayed.
Switch Specified/Unspecified of the time zone of target.
When selecting [Specify the time zone of target unit], set the time zone.
Time zone of target is set by specifying the time difference from GMT.
Settings of [Broadcast] in the utility
Configure the settings in the utility and in [GOT Setup] on GT Designer3 by the same method.
GT Designer3 (GOT2000) Screen Design Manual
14.1 Time Setting and Display
CH 1/CH 2/CH 1,CH 2/None
<Default: CH 1>
Trigger type: Rise/Fall/Sampling
Sampling interval: 1 to 1440
GMT-12:00 to GMT+13:00/Custom
Hour: -12 to 13
Minute: 0, 15, 30, or 45
<Default: 0 hour 0 minute>
14 - 9