Error Message List - Mitsubishi Electric GOT2000 Series User Manual

Graphic operation terminal
Hide thumbs Also See for GOT2000 Series:
Table of Contents

Advertisement

19. ERROR MESSAGE LIST

This chapter describes the error message and the corrective actions displayed on the GOT.
Error message
• Specified base screen does not exist in the project data.
SCREEN DOES NOT EXIST.
• Specified base screen is out of the permissible area. Specify the existing base screen.
The monitored device No. is out of the permissible area of the targeted PLC CPU.
SCREEN ERROR
Set the device within the range that can be monitored by the monitored PLC CPU and parameter settings.
Error occurred while writing in the device.
COMM. ERROR
• Check the cable omission and the status of the PLC.
Error occurred while writing in the device.
DEVICE ERROR.
Correct the device.
SET NUMBER IS
The input value was illegal when writing to the device.
INCORRECT.
Check the input value.
The operation, which could not be performed during RUN of PLC CPU, was performed.
PLC IS RUNNING.
Stop the PLC CPU.
The memory cassette installed in the PLC CPU is EPROM or E2PROM, and it is in a protected status.
CAN NOT WRITE.
Confirm the memory cassette installed in PLC CPU.
The key word is set in PLC CPU.
THIS FUNC IS PROTECTED.
Cancel the key word.
The function cannot be used with the package data configuration written in the GOT.
CAN NOT USE THE
• Review the package data configuration.
FUNCTION.
• Install the latest version of GT Designer3 and write the package data again to the GOT.
The package data is not downloaded or the package data is not sufficient.
DATA IS NOT FOUND.
Download the package data.
PASSWORD IS
The input password does not match the security level password or the utility start-up password.
INCORRECT.
Check the target password.
Password cannot be changed
When authenticating the operator, the password cannot be changed before logging in.
because you are not logged
Log in.
in.
The password does not
The passwords for transmitting the data from package data on Drive C and package data directly started from memory card do
match, the GOT cannot be
not match, so the GOT cannot be started.
booted.
Match the data transmission passwords.
Action
19
19 - 1

Advertisement

Table of Contents
loading

Table of Contents