Mitsubishi Electric GOT2000 Series User Manual page 550

(4) LCPU
Item
Parameter
Intelligent function
module parameter
Program
Device comment
Boot setting file
Device initial value
*1
File register
Sampling trace file
Programmable controller
user data
File for storing device
data
Drive headline sentence
Remote password
Monitor sequence
extension
Latch data backup file
Data logging setting file
Menu definition file
*1
*2
*3
*4
(5) FXCPU
Item
Parameter
Device comment
Sequence program
*1
Special program
File register
Extension file register
Built-in CC-Link/LT
*3
setting
Special parameter
*1
*2
*3
15 - 50
15.8 Backup and Restoration
Parameter to operate the PLC
Parameter for the intelligent function module
Program for the operation by the CPU (including SFC)
Device comment to be stored to the PLC
Batch file to start a program from the ROM or others
Initial value setting of devices
File register data
Sampling trace data to collect the specified device data
*2
continuously at the specified timing
Data created by users and stored to the memory card
Device data that the SP.DEVST and S.DEVLD instructions use
Drive headline sentence
Remote password setting
Data to speed up the monitoring from other stations
The file where the backup data is stored by the latch data backup
function to the standard ROM
Data logging setting
Menu definition file
The file register in the Flash card installed to the CPU is always restored and overwritten without any notice.
Whether to restore or not to restore the file register in the SRAM card or the standard RAM can be selected in the dialog box
displayed when the restoration is executed.
When the file register is not restored, the existing file register is deleted and the program of the controller may not operate
properly.
When a problem occurs in the operation of the controller after the restoration, restore the data including the file register again.
Only the backup operation is available.
Parameter to operate the PLC
Device comment to be stored to the PLC
Program for the operation by the CPU
Positioning setting/Initial value parameter
File register data
*2
Extension file register data
CC-Link/LT parameter
Parameter for special adaptors and special blocks stored in the
*1
main unit
The backup and restoration can be performed only when the FX3U(C) or FX3G(C) series is used.
The backup and restoration can be performed only when the FX3U(C) series is used.
This data exists only in the FX3U-32MT-LT-2.
Description
Description
File name
PARAM.QPA
IPARAM.QPA
***.QPG
***.QCD
AUTOEXEC.QBT
***.QDI
***.QDR
***.QTD
***.*** (Any name)
DEVSTORE.QST
QN.DAT
00000000.QTM
MONITOR.Q0*
LCHDAT00.QBK
LOGCOM.QLG
LOG01.QLG to
LOG10.QLG
MENUDEF.QDF
File name
INFO.FPG