Least Input Increment And Least Output Increment - YASKAWA yasnac i80m Instruction Manual

2.1 CONTROL AXES
(Cont'd)
Least Input Increment and Least Output Increment 2.1.3
•
Least input increment
The minimum
input units that can be commanded
by punched
tape or
MDI
are
shown in Tables
2.1.7, 2.1.8 and 2.1.9.
Table 2.1.7 Least Input Increment
(Standard)
Linear Axis
Rotary Axis*
0.001 deg Metric Input 0.001
mm
0.001 deg
Inch Input
0.0001 in.
Table 2.1.8 Least Input Increment
(Sub Microns)
Rotary
Axis*--
Linear Axis
0.001 deg
Metric Input 0.0001 mm
Inch
Input 0.00001 in 0.001 deg
Table 2.1.9 Least Input Increment (Sub Sub-microns)
Linear Axis Rotary Axis*
0.001 deg
0.00001 mm Metric Input
0.000001 in 0.001
deg Inch Input
Selection of mm-inpul
or
inch-input is
set
by Pm0007D0.
•
Least output increment
Least
output
increment is
the
minimum unit of tool motion
and
mm-output or
inch-output depends on an option.
Table 2.1.10 Least Output Increment
(Standard)
Linear Axis Rotary Axis#
Metric Output 0.001
mm 0.00 l deg
Inch Output 0.0001 in.
0.001
deg
12
-