YASKAWA yasnac i80m Instruction Manual page 655

(2)
Operations
Use this function in the following procedures.
(D Search the
program
in MEM mode
to
prepare for
memory operation.
(E> Close the FSED M
to enter
FS edit mode.
@
After
confirming FSED S (in
FS edit mode output) in closed
status,
perform the cycle
start to start
the
memory
operation.
<D
The F and S and changed
to
its optimum values.
'
©
When the F and S
are changed
to
its optimum values,
close the FSED
MEM (FS memory)
to store
the actual values of F and S in NC.
The F and S values
can
be stored only during
FSED S
output
and also
memory
operation.
The F and S values
can
be stored
up to
128 times
(number
of times
FSED MEM is closed).
©
When
memory
of the
optimum
values
for one processing is completed,
set
the
memory operation
in hold
state
(STP).
@
When FSED CH (FS memory
change) is closed, the
message "FSED?
(Y/N)"
is displayed
on the operation screen.
When "Y" is
entered,
the stored F-and S values are reflected in NC
program.
When "N" is entered,
the
message
disappears. By closing
the signal
again, the
message will be redisplayed.
The F and S values can be reflected in NC
program only during FSED
S signal
output
and also
memory operation
in hold or interrupted status.
©
Open the FSEC CH (FS
memory
change).
©
Open the FSED M
(FS
edit mode)
.
Then the stored F and S values are
canceled.
I
-
631