Canon imagerunner advance C5550i User Manual page 204

● When you set <Off> in <Send via Server>, you are required to set <On> in
Send via Server> in advance. If this setting is <Off>, the setting in <Send via Server> cannot be
changed. It is recommended to set
<Register Standard Fields>
This setting is required for using an Internet fax service. If you do not use an Internet fax service, this
setting is not necessary. For more information, contact your Internet service provider.
<I-Fax Address>
Enter the I-fax address using the following format: adv01@example.com. When sending to a recipient
on the same network, use the following format: adv01@[192.168.11.100] (the recipient device
name@[IP address]).
<Mode:>
You can select the type of sending results that are displayed when
you want to check whether an I-fax is delivered to the recipient's machine, or select <Simple> if you
want to check whether an I-fax is delivered to a mail server. Note that you cannot confirm the delivery
status if the recipient's machine does not support the <Mode:> function.
● If you send an I-fax to a machine that does not support the <Mode:> function, <Awaiting result...> is
displayed when you press
It continues to be displayed until the time set in
passes.
2
Press <Destination Conditions>
<Paper Size>
Select the paper size to use when sending. Specify only <A4/LTR> if you send in A5.
<Compression Method>
Select compression method. The compression rate is highest for MMR, followed by MR, and then MH.
The higher the compression rate, the faster the transmission speed.
<Resolution>
Select a higher value to increase the resolution and image quality. However, selecting higher value
reduces the transmission speed.
<Divide Data>
If the size of the data being sent exceeds the maximum limit (
Sending>(P. 781) ), select whether you want to divide the data by size or by page.
● If you select <On>, the data is divided into smaller sizes that do not exceed the limit and is sent in
several sections. The recipient's device must be able to combine the data received.
● If you select <Off> in <Send via Server> (
sent without being divided, even if it exceeds the maximum limit.
<Receive in Color>
Basic Operations
<Send>(P. 775)
to check the delivery status, even if the transmission is complete.
specify each setting and press <OK>.
) in step 1 for configuring the I-fax setting, the data is
192
<Send>(P. 775)
<Allow MDN Not via Server> to <On>.
is pressed. Select <Full> if
<Send>(P. 775) <Full Mode TX Timeout>
<Maximum Data Size for
<Use