Canon imagerunner advance C5550i User Manual page 986

◼
#886
When sending with WebDAV, a response indicating that the request was invalid was received from the
destination (received HTTP Error 400: Bad Request).
● When sending via a proxy with non-TLS communication, set <Use Divided Chunk Send for WebDAV TX> to
<Off>.
<Use Divided Chunk Send for WebDAV TX>(P. 777)
◼
#889
The original could not be scanned or printed because it was embedded with job restriction information.
● Check the job restriction information or contact your administrator.
◼
#899
E-mail or I-fax transmission completed normally. However, the transmission may not have been received
by the other party because it is relayed by multiple servers.
● When performing POP reception, press
received an error mail.
Receiving I-Faxes(P. 377)
● When performing POP reception, received error mails are automatically printed when <POP Interval> is
set to a value other than 0 minutes or the machine is set to receive error mails via SMTP.
Setting E-mail/I-Fax Communication(P. 62)
● Ask whether the other party received the transmission, as necessary.
◼
#918
Could not recognize the QR code in the original.
● Check whether the QR code is in the correct position and scan the original again.
◼
#919
A syntax error or a PostScript error that exceeds device restrictions, etc. was detected.
● Set <Print PS Errors> (Settings/Registration) to <On>, submit the job again, confirm the contents of the
PostScript error, then execute the job after resolving the error.
◼
#922
The maximum number of sheets that can be saddle-stitched has been exceeded. Saddle-stitching may be
able to be performed by reducing the number of sheets.
● Check the maximum number of sheets that can be saddle-stitched, and execute again.
◼
#925
A transmission error occurred from the fax driver.
● An image size that cannot be sent was specified. Check the size of the image.
Troubleshooting
<Check I-Fax RX>, and check whether the machine has
974