Canon imagerunner advance C5550i User Manual page 938

Could not verify CRL.
Could not confirm the CA certificate of the certificate authority that issued the certificate revocation list
(CRL).
● Register the CA certificate of the certificate authority that issued the certificate revocation list (CRL).
Registering a CA Certificate(P. 667)
D1 Replot Buffer Full
Could not redraw because data could not be registered to the replot buffer.
● Press <Skip Error>, and continue printing. However, the data that caused the error will not be printed
correctly. For information on the replot buffer, see Print.
D1 Div. Print. Bffr Full
Could not perform divided printing because data could not be registered to the buffer for divided
printing.
● Cancel printing, set <Divide Mode> to <No> and <Enlarge/Reduce> to <Auto> in the HP-GL setup menu,
specify the output paper size, and perform printing again. However, the data will be enlarged/reduced
when printed.
Canceling Printing(P. 385)
Print
● Press <Skip Error>, and continue printing. However, the data that could not be registered will not be
printed correctly. For information on divided printing, see Print.
D1 Polygon Buffer Full
Could not draw because data could not be registered to the polygon buffer.
● Press <Skip Error>, and continue printing. However, the data that could not be registered will not be
printed correctly. For information on the polygon buffer, see Print.
D0-nn error (nn is two alphanumeric characters)
The printer stopped operating normally due to an unknown problem.
● Restart the machine. If the message is still displayed after restarting the machine, make a note of the
message and contact your local authorized Canon dealer.
FF FONT FULL
Could not register font information in the font table because there were too many fonts to register.
● Cancel printing, initialize the printer to increase the free memory, and then try printing again. However,
note that initializing the printer will erase all the data in the memory of the machine.
Canceling Printing(P. 385)
Setting the Machine (PS/PCL/UFR II Printer)
● Press <Skip Error>, and continue printing. However, the data that could not be registered will not be
printed correctly.
Troubleshooting
926