Table of Contents
Advertisement
Correcting the media feed rate [MEDIA COMP.]
When the media type or heater temperature is changed, the amount of media feed
changes. Be sure to correct dot positions.
If the correction value is not appropriate, stripes may occur in the plotting, disturbing neat
plotting.
• When the heater temperature is changed, make sure that the CONSTANT
indicator is lit and the set temperature is reached before making correction.
• When in use of a roll media, the back side of roll media will loosen after
executing media comp., for the media returns to the plot original point.
CORRECTING PATTERN
Plot two bands.
Adjust the plot density so that the boundary of the two bands is plotted with an even den-
sity.
Setting value : -255 - 255
STEPS:
1. Make sure that the menu is the LOCAL mode.
2. Press the [FUNCTION] key.
3. Press the [ENTER] key.
4. Press the Jog key [ ] ot [ ] to select a type.
page 4.4
Second band
First band
Out put direction
- 2.24 -
< LOCAL >
width : 1272 mm
FUNCTION
SET UP
< ENT >
SET UP
SELECT
: TYPE. 1
SET UP
SELECT
: TYPE. 1
Advertisement
Table of Contents
