Correcting The Medium Feed Rate During Printing [Feed Comp.] - MIMAKI Textile Jet Tx3-1600 Operation Manual

Correcting the Medium Feed Rate During Printing [Feed Comp.]

Even for fabric of the same type, if the thread size or texture is slightly different, the proper value of
the feeding amount changes.
In this case, correct the feeding amount of the fabric while checking the printing condition.
• To change the fabric type or print data, be sure to perform [Feed Comp.].
• This function can be operated even during data printing.
Correction values can be entered while checking the fabric condition and
data printing condition.
STEP
• During [Feed Comp.] printing, does not print correction patterns. Perform
only correction value input operation while checking print data.
1. Make sure that the device is the REMOTE
mode.
2. Press [FUNCTION] key to confirm the current
setting value.
Press the [END] key when an appropriate value is set or to abort
the operation.
3. Press [ENTER] key.
Available to alter the fabric feed rate.
4. Press jog key [ ] or [ ] as needed to set the
amount of correction.
Setting value is available from -500 to +500. Press [END] key to
return to the REMOTE display. The altered value ceases to be in
effect, and returns to the previous value.
• A new value takes effect in real time. The
best effect can be obtained while checking
the result.
- 2.46 -
Feed Comp.
Adjust
Feed Comp.
Adjust = 100
Feed Comp.
Adjust = 100
−200
: ent
−200
−200