Correcting The Media Feed Rate [Media Comp.] - MIMAKI JV3-75 SP II Operation Manual

Correcting the media feed rate [MEDIA COMP.]

When the media type or heater temperature is changed, the amount of media feed changes. Be sure
to correct dot positions.
If the correction value is not appropriate, stripes may occur in the plotting, disturbing neat plotting.
• When the heater temperature is changed, make sure that the CONSTANT
indicator is lit and the set temperature is reached before making correction.
• When in use of a roll media, the back side of roll media will loosen after
executing media comp., for the media returns to the plot original point.
CORRECTING PATTERN
Plot two bands.
Adjust the plot density so that the boundary of the two bands is plotted with an even density,
Setting value : -255 - 255
Correction value is too large
Correction value is too small
Second band First band
Get between lines
Overlap
Out put direction
- 2.23 -