Table of Contents
Advertisement
When medium thickness is changed [PRINT ADJUST]
When the head height is adjusted, be sure to correct the dot positions.
The dot position adjustment function enables to set the two kinds of adjustmens, high/low, according
to the current use head height, for the appropriate head position is subtly different according to the
head height.This function corrects the dot positions to ensure that the accurate plotting result is
obtained.
The dot positions are corrected by comparing the ink dropping positions on each of the seven test
patterns between the two plotting directions.
• When in use of a roll medium, the back side of roll medium will loosen after
executing print adjust, for the medium returns to the plot original point.
STEP
1. Select the [PRINT ADJUST].
2. Push the [ENTER] key.
3.
Use the jog keys [ ][ ] to select a head
height.
One of the two head heights may be selected.
[LOW], [HIGH]
Check the actual head height and select the applicable
height.
4. Push the [ENTER] key.
Plotting of the test patterns for the correction of dot position
starts. There are seven types of test patterns that are plotted.
5. Push the JOG keys [ ] and [ ] to correct the
dot position of pattern 1.
The seven test patterns that are output are sequentially
named [PATTERN 1] to [PATTERN 7].
Select the correct dot positions on [PATTERN 1] using the
JOG keys [ ] and [ ].
Select the dot positions that make a straight line on the test
pattern in the two plotting directions.
- 5.9 -
MAINTENANCE
PRINTadjust
MAINTENANCE
HEAD HEIGHT
MAINTENANCE
HEAD HEIGHT
MAINTENANCE
PRINT START
MAINTENANCE
PATTERN 1
< ent >
: LOW
: HIGH
: ent
= 0. 0
Advertisement
Table of Contents
