Table of Contents
Advertisement
When media thickness is changed [PRINT ADJUST]
The dot positions are corrected by comparing the ink dropping positions on each of the seven test
patterns between the two plotting directions.The dot position adjustment function enables to set the
two kinds of adjustmens, high/low, according to the current use head height, for the appropriate head
position is subtly different according to the head height. This function corrects the dot positions to
ensure that the accurate plotting result is obtained.
STEP
1. Select the [PRINT ADJUST].
2. Push the [ENTER] key.
3.
Use the jog keys [ ][ ] to select a head
height.
One of the two head heights may be selected.
LOW], [HIGH]
Check the actual head height and select the applicable
height.
4. Push the [ENTER] key.
Plotting of the test patterns for the correction of dot position
starts. There are seven types of test patterns that are plotted.
5. Push the JOG keys [ ] and [ ] to correct the
dot position adjustment value of pattern 1.
The seven test patterns that are output are sequentially
named [PATTERN 1] to [PATTERN 7].
Select the correct dot positions on [PATTERN 1] using the
JOG keys [ ] and [ ].
Select the dot positions that make a straight line on the test
pattern in the two plotting directions.
Downloaded From ManualsPrinter.com Manuals
• When in use of a roll media, the back side of roll media will loosen after
executing print adjust, for the media returns to the plot original point.
MAINTENANCE
PRINTadjust
MAINTENANCE
HEAD HEIGHT
MAINTENANCE
HEAD HEIGHT
MAINTENANCE
PRINT START
MAINTENANCE
PATTERN 1
- 5.10 -
< ent >
: LOW
: HIGH
: ent
= 0. 0
Advertisement
Table of Contents
