Table of Contents
Advertisement
When media thickness is changed [Print Adjust]
When the head height is adjusted, be sure to correct the dot positions.
This function corrects the dot positions to ensure that the accurate printing result is ob-
tained.
The dot positions are corrected by comparing the ink dropping positions on each of the six
test patterns between the two printing directions.
+15
Print direction
Always perform Print Adjust (dot position correction) whenever the head height is changed.
STEPS:
1. Set a sheet of paper, use 297mm x 210mm
or larger size with the long side set hori-
zontally, and set the Origin.
2. Select the [PRINT ADJ] from the [MAINTE-
NANCE]. (
3. Press the [ENTER] key.
Gap check is performed when the head gap
adjustment has not been checked. (
+10
+5
P.5-2)
0
-5
P.2-13)
- 5-4 -
-10
-15
Pattern 6
Pattern 5
Pattern 4
Pattern 3
Pattern 2
Pattern 1
Head moving direction
MAINTENANCE
PRINT ADJ
PRINT ADJUST
PRINT START
< ent >
: ent
Advertisement
Table of Contents
