Adjust Print Head Height - MIMAKI TS100-1600 Operation Manual

2.2 Adjust Print Head Height

Adjust the height of the print head according to the thickness of the media you are using.
Range
Low
High
• Be sure to correct the dot position after altering the print head height.
Position"(P. 65)
• Adjust the print head height to suit the media. With inkjet printers, if the gap between the print
and media increases, the ink droplets may vaporize before they reach the media. Vaporized ink
may adhere to the print head nozzle surface and media, affecting print quality and causing
failure of the print head.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Platen Right End], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the front cover.
4
Unscrew the carriage cover screws.
• Use a flathead screwdriver to unscrew by approximately one turn.
5
Use the height adjustment lever to adjust the height.
• Set the height adjustment lever so that the desired height is at the top. If the lever is not set to the
correct position, problems such as media jamming and misting may occur, resulting in impaired
print quality.
Height adjustment
lever
Height adjustment lever
51
Chapter 2 Printing
Gap between print head and platen
3.0 mm (default setting)
3.5 mm
"Correcting the Drop
Hi
Low
2