Recovery Method Of Defective Nozzle Discharge; When The Printer Is Not Used For A Long Period - MIMAKI JV300-130A Requests For Care And Maintenance

8. Recovery method of defective nozzle discharge

When this printer has not been used for an extended period of time, or depending on the environmental tem-
perature, the discharge at the nozzles could become unstable. In such a case, the following methods may be
taken to recover the status of the nozzles.
For symptoms 1 to 4 in P.9 "The examples of defective printing"
1. Daily maintenance and care

Perform the cleaning of the parts described in this document.
2. Performing Head Cleaning (normal). Refer to Chapter 2 of
Operation Manual.

After having performed the care and maintenance stated in step 1, perform
the cleaning of the heads in accordance with the procedures stated in
Operation Manual.
3. Performing Head Cleaning (hard). Refer to Chapter 2 of
Operation Manual.

If the nozzle missing does not disappear even after repeating the head
cleaning (normal) several times, reset the cleaning mode to "hard" and
perform the cleaning again.
4. Perform the cleaning of the head nozzles. Refer to Chapter
4 of Operation Manual.

Perform the cleaning of the head nozzles. In this case, leaving time of the
cleaning liquid for maintenance shall be made [1 minute].
5. Perform the cleaning of the head nozzles again. Refer to
Chapter 4 of Operation Manual

Reset the leaving time of the cleaning liquid for maintenance to [10
minutes], and perform the cleaning of the head nozzles again.

9. When the printer is not used for a long period

When the printer is not to be used for a period of one week or above, perform the cleaning of the heads and
nozzles and the ink discharging channel before storing this printer.
10. Supplies
Product Name
Cleaning Liquid Bottle Kit A29 for sublimation dye ink
Waste ink tank
Cutter blades ASSY
Clean stick for the surroundings of the head 50pcs
In the event nozzle missing etc. have not been improved
In the event nozzle missing etc. have not been improved
In the event nozzle missing etc. have not been improved
Product No.
SPC-0137
SPA-0246
SPA-0107
SPC-0527
10
Perform test printing and
check
(Chapter 2 of Operation Manual)
Perform test printing and
check
(Chapter 2 of Operation Manual)
Perform test printing and
check
(Chapter 2 of Operation Manual)
Perform test printing and
check
(Chapter 2 of Operation Manual)
Product Name
Pinch roller
Exhaust BOX
Exhaust BOX filter
Wiper kit 33S
Product No.
SPA-0247
SPA-0248
SPA-0249
SPA-0134