Switching Display Modes - Hitachi Compute Blade 500 Series User Manual

Connector
Enclosure ID
Mode name
Vendor
Revision
Slot Number
Device Type
Connected Port
Media Errors
Pred Fail Count
SAS Address
Physical Drive State
Certified
FDE Capable
Max Device Speed
Link Speed
Temperature (Celsius)
Commissioned Hotspare
Tip:
• Items described in the table above cannot be changed.
• For hard disk status, see
• Media Errors and Pred Fail Count information is cleared when the
system unit is powered off.

Switching display modes

This section describes switching disk array display modes in the main menu.
There are two types of display mode: Logical View and Physical View.
The Logical View mode displays a list of disk array configurations that are
already set.
The Physical View mode displays a list of physical disks comprising a disk
array configuration.
4-26
Table 4-12 Disk property menu
Menu items
Connector of the connected disk array controller board
ID number of the connected enclosure device
Disk mode name
Vendor name
Firmware version
Number of the slot installed
Device type
Port number of the connected disk array controller board
Number of detected media errors
Number of reported S.M.R.T warnings
SAS address
Status
Certification
With or without encryption function
Maximum speed at which a physical disk can operate
Link speed of an interface
Disk temperature
Fault tolerance by Hotspare
MegaRAID WebBIOS for storage expansion blades
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Status on page 4-91.