Hitachi Compute Blade 500 Series User Manual page 332

Stop Consistency Check
on Error
Maintain Drive Fail
History
Load Balance
Enable Auto Import
Persistent Hot Spare
Manage Link Speed
Spin Down
Unconfigured Good
Spin Down Hot Spare
Drives
Drive Standby Time
Spinup Drive Count
Spinup Delay
Patrol Read State
Patrol Read Iteration
Patrol Read Mode
Patrol Read Rate
Start Patrol Read
Suspend Patrol Read
Resume Patrol Read
5-24
Menu items
Set a behavior when an error
is detected at consistency
check.
Failed hard disk is used or
not.
Load balancing
Loads foreign configuration
automatically.
Sets hot spare automatically.
Transfer speed of the
1
physical drive
Spin down setting for unused
hard disks
Spin down setting for a hard
disk assigned to hot spare
Time that takes a drive goes
to standby mode
Number of hard disk motors
to start at the system boot
A timing when hard disk
motors start up at the
system boot.
Patrol read status
Number of patrol read
processes
Operational conditions for
patrol read
Priority of patrol read
processes
1 Starts Patrol Read.
Suspends Patrol Read.
1
1 Resumes Patrol Read.
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
View/description Value/view/reference
iMR) / [Pause on errors
(Suspends when an error
occurs) (Recommendable
value with using SAS 3004
iMR) / <<Stop on errors
(Stops when an error
occurs)>>
Enabled (Stops consistency
check) / [<<Disabled
(Continues running)>>]
[<<Enabled (Saves failed
hard disk information)>>] /
Disabled (Not saves failed
hard disk information)
[<<Auto (valid)>>] /
Disabled (invalid)
[<<Enabled (valid)>>] /
Disabled (invalid)
[<<Enabled (valid)>>] /
Disabled (invalid)
-
Enabled (valid) /
[<<Disabled (invalid)>>]
Enabled (valid) /
[<<Disabled (invalid)>>]
30 Minutes to 24 Hours /
[<<30 Mins>>]
[2]
[6]
-
-
[<<Auto (automatic)>>] /
Disabled (invalid) / Manual
(valid)
[<<30>>]
-
-
-