Hitachi Compute Blade 500 Series User Manual page 97

Table 2-67 System Settings menu items
Menu items
Adaptors and UEFI
Drivers
Processors
Memory
Devices and I/O Ports
Operating Modes
Legacy Support
System Security
RAS Configuration
Storage
Network
Processors sub menu
Select an item to display or set, and press Enter.
The following table shows description of menu items appeared in the left side
of the window.
Select an item to display or set, and press Enter.
Menu items
Turbo Mode
Processor
Performance States
C-States
Package ACPI C-
State Limit
C1 Enhanced Mode
Hitachi Compute Blade 500 Series EFI User's Guide
Displays information about adapters and UEFI drivers on the
server blade.
Displays and provides option to change the processor settings.
See Processors sub menu on page
Displays and provides option to change the memory settings.
See Memory sub menu on page
Displays devices and I/O port options of settings.
Selects the operating mode desired based on your preference.
Selects the legacy support.
Selects the TPM setup options.
See System Security sub menu on page
Sets RAS configuration.
See RAS Configuration sub menu on page
Selects this option to see all the Storage Device options.
Selects the Network setup options
Table 2-68 Processors menu items
1
Selection
• Disable
• <<Enable>>
• Disable
• <<Enable>>
• Disable
• <<Enable>>
• ACPI C2
• <<ACPI C3>>
• Disable
• <<Enable>>
UEFI setup menu
Description
2-77.
2-78.
2-80.
2-81.
Description
Sets a CPU Turbo Mode, which is
enabled after the reboot.
Shown only when supported by
installed CPUs.
Sets CPU EIST, which is enabled
after the reboot.
Sets a CPU power saving mode,
which is enabled after the reboot.
Sets a C-State upper limit during
the CPU idle mode.
Sets CPU Enhanced C1E State,
which is enabled after the reboot.
2-77