Hitachi Compute Blade 500 Series User Manual page 402

9 Virtual Drive Management > Create Configuration > Select Drives >
.
Success message appears. With OK selected, press Enter.
10 The window returns to Create Configuraion. Select Save Configuration
.
and press Enter.
11 Virtual Drive Management > Create Configuration > Warning message
.
appears. Select Yes and press Enter.
Tip: When you select No, the configuration will not saved and the window
returns to Create Configuration window.
12 Virtual Drive Management > Create Configuration > Success message
.
appears. With OK selected, press Enter.
13 Configuration Options window appears.
.
When using a drive installed in port 1 for a single drive configuration,
execute step 1 through step 12 again.
Tip: When using a drive installed in port 1 for a single drive configuration,
select Drives Target ID: 1: SATA (a drive in slot 1) SATA, xxxx.xxxx
GB, Unconfigured Good (a drive recognized as Unconfigured Good) in
step 6 for drive selection.
14 Initialize virtual drives after configuring them. See
.
drives on page
Note: When newly creating virtual drives, make sure to initialize those
virtual drives. If not, those virtual drives do not work properly.
6-24
6-25.
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide
Initializing virtual