Hitachi Compute Blade 500 Series User Manual page 127

Menu items
Optimized Boot •
Quiet Boot
Fast Boot
Note:
1 A value in double angle brackets, << >>, shows the default.
.
Note: Important:
In order to use the Fast Boot, the system must have internal system
configuration data which is created by EFI at OS bootup.
If user changed a system settings, the internal system configuration data
must be renewed by OS bootup with Fast Boot disabled.
The following conditions are required for Fast Boot.
• User must boot an OS on the system at least one time before using Fast
Boot.
• Any system configuration change (such as Memory or I/O) will not be
allowed during using FastBoot.
• Not after Load default setting or not after FW Update.
• Not after change the Memory RAS setting and others.
Note: Important:
The following features doesn't work when FastBoot enabled.
N+M cold Standby
Some health check features such as POST retry, Link check
System Event Logs
The System Event Logs of server blade are displayed.
1
Selection
<<Enable>>
• Disable
• <<Enable>>
• Disable
• Enable
• <<Disable>>
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Legacy Mode: Uses Option ROM, not UEFI Driver.
Select this for OS boot in Legacy mode.
Sets Optimized Boot where minimum drivers are
loaded to optimize the boot time.
Sets Quiet Boot where the system summary view
is prevented.
Sets whether to reduce the boot time or not.
Shown with the server blade firmware version
06-10 or later.
Important:
The following features are limited when Fast
Boot is enabled.
• N+M Cold Standby
• Retry POST when detected Memory error
• PCIe Link Check
• High reliability log base (only the log
collection functionality)
2-107