Hitachi Compute Blade 500 Series User Manual page 209

Message
Foreign configuration(s) found on
adapter.
FW package: xxxx
The battery hardware is missing or
malfunctioning, or the battery is
unplugged. If you continue to boot the
system, the battery-backed cache will not
function. Please contact technical support
for assistance.
Press [D] to disable this warning (if your
controller does not have a battery).
Some configured disks have been
removed from your system, or are no
longer accessible. Please check your
cables and also ensure all disks are
present.
The following VDs have missing disks: X Y
If you proceed (or load the configuration
utility), these VDs will be marked
OFFLINE and will be inaccessible. Please
check your cables and ensure all disks are
present.
The following VDs are missing: X Y ...
If you proceed (or load the configuration
utility), these VDs will be removed from
your configuration. If you wish to use
them at a later time, they will have to be
imported. If you believe these VDs should
be present, please power off your system
and check your cables to ensure all disks
are present.
All of the disks from your previous
configuration are gone. If this is an
unexpected message, then please power
off your system and check your cables to
ensure all disks are present.
Press any key to continue, or [C] to load
the configuration utility.
MegaRAID WebBIOS for LSI SAS 2008
Hitachi Compute Blade 500 Series EFI User's Guide
Description
rebuilding, patrol read, or initializing
operation.
There may be a cache memory failure, if this
event is registered at the reboot after the
system hang in operation or after the OS
cannot boot up.
A disk with a different configuration from the
disk array configuration in the disk array
controller was detected.
This indicates the firmware package version.
You do not need to take any action.
Battery backed up unit information is not set
correctly.
Press the D key while this message is
displayed.
If not recovered, contact with your reseller
from which you purchased the product or
maintenance personnel.
Some disks with the disk array configuration
information have been removed. When this
message is displayed even if the device is
installed properly, contact your reseller from
which you purchased the product or counsel
maintenance personnel.
Since some disks have been removed, the
disk array is set to OFFLINE.
When this message is displayed even if the
device is installed properly, contact your
reseller from which you purchased the
product or maintenance personnel.
Some disk array configurations are removed.
When this message is displayed even if the
device is installed properly, contact your
reseller from which you purchased the
product or maintenance personnel.
All disks with disk array configuration
information have been removed.
When this message is displayed even if the
device is installed properly, contact your
reseller from which you purchased the
product or maintenance personnel.
Press the C key while this message is
displayed, then MegaRAID WebBIOS will
start.
3-59