Virtual Drive Configuration; To Create Raid 1 - Hitachi Compute Blade 500 Series User Manual

2 Type Y to end the UEFI setup menu. To return to the UEFI setup menu,
.
press ESC.

Virtual drive configuration

This section describes how to configure virtual drives.
Note: Do not change a virtual drive in operation. If you do, all data will be
lost from the virtual drive because changing virtual drives changes the virtual
drive information.
Note:
• Unless otherwise specified, make sure to set each item to the
recommended value. If you set it to any other value than recommended,
the system is out of support and may not work properly.
• When installing an OS after configuring virtual drives, make sure to see
the Hitachi Compute Blade Series Hitachi Compute Rack Series OS
Installation Guide for Windows Server or Hitachi Compute Blade 500
Series OS Installation Guide for Red Hat Enterprise Linux, a manual for
the system unit, to install the OS. If not, values for virtual drives cannot
be configured properly.
• When restoring the OS with ServerConductor/Deployment Manager after
configuring a virtual drive, add a virtual drive referring to
drives on page

To create RAID 1

This subsection describes how to create RAID 1.
1 On the Configuration Options window, select Virtual Drive Management
.
and press Enter.
2 Virtual Drive Management window appears. Select Create Configuration
.
and press Enter.
3 Virtual Drive Management > Create Configuration menu appears. Select
.
Select RAID Level and press Enter.
6-16
6-53. If not, LSI Software RAID may not work properly
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide
Setting virtual