Key Functions For Uefi Setup Menu; Starting Uefi Setup Menu; Uefi Setup Menu Window - Hitachi Compute Blade 500 Series User Manual

Key functions for UEFI setup menu

The following table describes key functions in the UEFI setup menu.
[↑], [↓], [←], [→]
[Enter]
[Esc]
[Space]
[+], [-]
Note: You can only operate key functions for UEFI setup menu.

Starting UEFI setup menu

To start up the UEFI setup menu, follow the steps showing below.
1 Start the remote console, and then click Power > Power On to power on
.
a server blade.
2 When <F1> Setup is displayed in the bottom of the window during the
.
server blade startup, press F1 key.
Tip: The following window appears when EFI firmware has started from
the Secondary EFI ROM due to a Primary failure. On this window, press
F1 key to start the setup menu as well.
3 The setup menu is booted and System Configuration and Boot
.
Management window will be displayed.
Tip: When the OS has started before pressing the key, shut down the OS
and restart the server blade. To shut down the OS, refer to the
documents attached to your OS.

UEFI setup menu window

When the UEFI setup menu starts, the following System Configuration and
Boot Management window is displayed.
Table 2-1 Key functions
Keys
Moves the cursor up, down, left, and right in the menu.
Displays the submenu.
Performs the command.
Exits the submenu.
Moves to the exit window.
Checks the check box.
Increases or decreases the setting value.
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide
Description
2-3