Hitachi Compute Blade 500 Series User Manual page 163

Menu items
Alarm Control
3
Patrol Read Rate
3
Cache Flush Interval
4
Spinup Drive Count
3
Spinup Delay
Notes:
1 This can be changed only when no disk arrays have been set at all.
.
2 Do not use "Set Factory Defaults." This setting must be changed to the
.
recommended values.
3 Always use the "Default" setting.
.
4 Always use the recommended values.
.
Tip: Place the mouse cursor on a setting item and left-click the mouse to
change the setting values. Or, left-click the mouse to move the cursor and
enter a value from the keyboard. Click Submit after the setting.
Controller properties submenu 2
Click Next in the Properties: Controller properties submenu 1 window.
The following window is displayed.
Note: Do not set the value of items Stop CC On Error, Schedule CC,
Maintain PD Fail History, Disk Activity, and Manage Powersave.
They are not supported.
MegaRAID WebBIOS for LSI SAS 2008
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Sounding the buzzer on the
controller in the event of failure
at a connected device
Priority of patrol reading
Flush timing for write-cache data 1 to 255 / [<<4>>]
Number of disk motors to start
at system startup
Timing for disk motors to start at
system startup
Setting/display value
[<<Disabled (not
sounding)>>]
0 to 100 / [<<30>>]
0, <<1>> to 8 / [2]
0 to xxx / [<<6>>]
3-13