Menu Configuration Of Megaraid Webbios; Main Menu - Hitachi Compute Blade 500 Series User Manual

Menu items for MegaRAID WebBIOS are displayed. Click each item to go
to the respective menu window.
3 Logical View/Physical View
.
Disks or disk arrays connected to the disk array controller are displayed.
Tip:
•
•

Menu configuration of MegaRAID WebBIOS

This section describes the setting items and values for MegaRAID WebBIOS.
• In the table for each menu, default values are enclosed in << >>.
• In the table for each menu, recommended values are enclosed in [ ].
Example:
[<<Enabled (valid)>>]/Disabled (invalid): "Enabled" is the default and also
recommended value.
[Enabled (valid)]/<<Disabled (invalid)>>: "Disabled" is the default value;
and "Enabled" is the recommended value, which requires the change.
Note: Unless otherwise specified, use the recommended values for all setting
items. If you set non-recommended values, the equipment would not be
supported and might not operate properly.

Main menu

Start MegaRAID WebBIOS, and the following main menu is displayed.
Click the target item that you want to set or display.
4-10
Click a disk from disks displayed in Logical View or Physical View,
and the same window is displayed as one when you select Drives >
Properties from the menu.
Select a disk array from disks displayed in Logical View, and the
same window is displayed as the one when you click Drives >
Properties from the menu.
MegaRAID WebBIOS for storage expansion blades
Hitachi Compute Blade 500 Series EFI User's Guide