Hitachi Compute Blade 500 Series User Manual page 69

Table 2-41 Recovery and RAS sub menu items
Menu items
Advanced RAS
Backup Bank Management -
Disk GPT Recovery
System Recovery
Advanced RAS
Select an item to display or set, and press Enter.
The following table shows description of menu items displayed in the left side
of the window.
Select the item to display or set, and press Enter.
Table 2-42 RAS Configuration menu items
Menu items
2 •
PCIe Isolation
•
Deconfigured Mode •
•
POST Fail Retry •
•
Note:
1 A value in double angle brackets, << >>, shows the default.
.
2 These items are displayed but are not available.
.
Security sub menu
Place the cursor on a menu to set, and press Enter.
Note: Do not change the settings of other than the following items. If you
change the settings, UEFI may not start up.
• Secure Boot Configuration
• Trusted Platform Module (TPM 1.2)
The following table shows description of menu items displayed in the left side
of the window.
Select a menu to set, and press Enter.
Hitachi Compute Blade 500 Series EFI User's Guide
Selection
- Sets the failure deconfiguration to CPU and
DIMM.
See Advanced RAS for details.
Sets the backup management.
- Set the disk GPT recovery
- Sets the system recovery.
1
Selection
Disable Sets PCIe isolation.
<<Enable>>
Disable Sets the Deconfigured mode.
<<Enable>>
Disable Enable or Disable POST Fail Retry. POST Retry is
performed automatically when EFI firmware
<<Enable>>
detects any memory failure at POST.
UEFI setup menu
Description
Description
2-49