Hitachi Compute Blade 500 Series User Manual page 367

Message
data Press Y to continue with extra
drives.
Multibit ECC errors were detected
on the RAID controller.
If you continue, data corruption
can occur.
Contact technical support to
resolve this issue.
Press X to continue or else power
off the system, replace the
controller and reboot.
Multibit ECC errors were detected
on the RAID controller. The DIMM
on the controller needs
replacement. Contact technical
support to resolve this issue.
If you continue, data corruption
can occur. Press X to continue or
else power off the system and
replace the DIMM module and
reboot.
If you have replaced the DIMM
press X to continue
Multiple Single-bit ECC errors were
detected during the previous boot
of the controller.
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
Description
a Press the Y key, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
An error occurred in the cache memory of the
disk array controller.
Action 1:
a Press the X key, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
An error occurred in the cache memory of the
disk array controller.
Action 1:
a Press the X key, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
An error occurred in the cache memory of the
disk array controller.
Action 1:
5-59