Hitachi Compute Blade 500 Series User Manual page 307

Message
Drive security is enabled on this controller and a
pass phrase is required. Please enter the pass
phrase
Invalid pass phrase. Please enter the pass phrase.
There was a drive security key error. All secure
drives will be marked as foreign. Press any key to
continue, or C to load the configuration utility.
Invalid pass phrase. If you continue, there will be a
drive security key error and all secure
configurations will be marked as foreign. Reboot
the machine to retry the pass phrase or press any
key to continue.
Unable to communicate to EKMS. If you continue,
there will be a drive security key error and all
secure configurations will be marked as foreign.
Please check connection with the EKMS, reboot the
machine to retry the EKMS or press any key to
continue.
Unable to change security to EKMS as not able to
communicate to EKMS. If you continue, the drive
security will remain to existing security mode.
Please check connection with the EKMS, reboot the
machine to retry the EKMS or press any key to
continue
DKM existing key request failed; existing secure
configurations will be labeled foreign and will not
be accessible. Reboot server to retry.
DKM new key request failed; controller security
mode transition was not successful. Reboot server
to retry request, or press any key to continue
The native configuration is no longer supported by
the current controller settings. Please ensure that
correct controller, iButton or key vault is being
used. If you continue, the configuration will be
marked foreign and part of it may be imported if
possible. Press any key to continue.
The battery is currently discharged or
disconnected. Verify the connection and allow 30
minutes for charging. If the battery is properly
connected and it has not returned to operational
state after 30 minutes of charging, contact
technical support for additional assistance.
Press D to disable this warning (if your controller
does not have a battery).
The battery is currently discharged or
disconnected. VDs configured in write-back mode
will run in write-through mode to protect your
data, and will return to write-back policy when the
battery is operational. If VDs have not returned to
write-back mode after 30 minutes of charging then
MegaRAID WebBIOS for storage expansion blades
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Hard disk security functions are not
supported. When this message is
displayed, contact your reseller or
call maintenance personnel.
The native configuration is not
supported by the current disk array
controller settings. When this
message is displayed, contact your
reseller or call maintenance
personnel.
Cache backup module information is
incorrect. When this message is
displayed, contact your reseller or
call maintenance personnel.
4-97