Hitachi Compute Blade 500 Series User Manual page 368

The DIMM on the controller needs
replacement.
If you continue, data corruption
can occur.
Press X to continue or else power
off the system, replace the DIMM
module, and reboot.
If you have replaced the DIMM,
press X to continue.
On-board expander firmware or
mfg image is corrupted.
Flash expander firmware and mfg
image using recovery tools.
SAS drives were detected, but this
controller does not support SAS
drives.
Remove the SAS drives and restart
your system.
Press any key to continue or press
C to load the configuration utility.
SATA drives were detected, but
this controller does not support
SATA drives.
Remove the SATA drives, and
restart your system.
Press any key to continue or press
C to load the configuration utility.
5-60
Message
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
Description
a Press the X key, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
The expander is invalid.
Action:
If this message appeared, contact your reseller
or call maintenance personnel.
If this message appeared, the system startup
cannot continue.
Cause:
Incorrect enclosures were detected.
Action 1:
a Enter a character, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
a Press the C key, and then press the Enter
.
key.
b The LSI MegaRAID <HITACHI SAS 3004
.
iMR ROMB> Configuration Utility restarts.
Action 3:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
Incorrect enclosures were detected.
Action 1:
a Enter a character, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.