Raid 0: To Create Single Physical Drive Configuration - Hitachi Compute Blade 500 Series User Manual
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (456 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
13
Configuration Options window appears. Then, initialize the virtual drives
.
configured. See
Note: When newly creating virtual drives, make sure to initialize those virtual
drives. If not, those virtual drives do not work properly.
RAID 0: To create single physical drive configuration
This subsection describes how to create RAID 0 single physical drive
configuration.
Note: Since RAID 0 single physical drive configuration has no redundancy, all
data will be lost when the drive fails. It is recommended that you configure
RAID 1 for having data redundancy and increasing failure resistance.
1
On Configuration Options window, select Virtual Drive Management
.
and press Enter.
2
Virtual Drive management window appears. Select Create Configuration
.
and press Enter.
3
Create Configuration window appears. Select Select RAID Level and
.
press Enter.
4
The following subwindow appears in the middle of the Create
.
Configuration window. Select RAID0 and press Enter.
6-20
Initializing virtual drives on page
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide
6-25.
Hide quick links:
Advertisement
Table of Contents
