Spanning-Tree Portfast Bpdu-Guard - Allied Telesis AT-AR3050S Command Reference Manual

S T C
PANNING REE OMMANDS
-
SPANNING TREE PORTFAST BPDU

spanning-tree portfast bpdu-guard

Overview The AR3050S and AR4050S devices don't support BPDU protection in 5.4.5-0.1
release.
This command applies a BPDU (Bridge Protocol Data Unit) guard to the port. A port
with the bpdu-guard feature enabled will block all traffic (BPDUs and user data), if
it starts receiving BPDUs.
Use this command in Global Configuration mode to apply BPDU guard to all ports
on the device. Use this command in Interface mode for an individual interface or a
range of interfaces specified. BPDU Guard is not enabled on a port by default.
Use the no variant of this command to disable the BPDU Guard feature on a device
in Global Configuration mode or to disable the BPDU Guard feature on a port in
Interface mode.
spanning-tree portfast bpdu-guard
Syntax (Global
Configuration)
no spanning-tree portfast bpdu-guard
spanning-tree portfast bpdu-guard {default|disable|enable}
Syntax (Interface
Configuration)
no spanning-tree portfast bpdu-guard
Default BPDU Guard is not enabled on any ports by default.
Mode Global Configuration or Interface Configuration
Usage This command blocks the port(s) to all devices and data when enabled. BPDU
Guard is a port-security feature that changes how a portfast-enabled port behaves
if it receives a BPDU. When bpdu-guard is set, then the port shuts down if it
receives a BPDU. It does not process the BPDU as it is considered suspicious. When
bpdu-guard is not set, then the port will negotiate spanning-tree with the device
sending the BPDUs. By default, bpdu- guard is not enabled on a port.
You can configure a port disabled by the bpdu-guard to re-enable itself after a
specific time interval. This interval is set with the
C613-50077-01 REV A
-
GUARD
Parameter Description
bpdu-guard
A port that has bpdu-guard turned on will enter the STP blocking state
if it receives a BPDU. This port type has one of the following
parameters (in Interface Configuration mode):
default Takes the setting that has been configured for the whole
disable Turns off BPDU guard.
enable
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
device, i.e. the setting made from the Global configuration
mode.
Turns on BPDU guard and will also set the port as an edge
port.
spanning-tree errdisable-timeout
510