Timers Spf Exp (Ipv6 Ospf) - Allied Telesis AT-AR3050S Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
(IP 6 OSPF)
TIMERS SPF EXP V

timers spf exp (IPv6 OSPF)

Overview Use this command to adjust route calculation timers using exponential back-off
delays.
Use no form of this command to return to the default exponential back-off timer
values.
Syntax timers spf exp <min-holdtime> <max-holdtime>
no timers spf exp <min-holdtime> <max-holdtime>
Mode Router Configuration
Usage This command configures the minimum and maximum delay time between the
receipt of a topology change and the calculation of the Shortest Path First (SPF).
The time between SPF runs increases if a topology change occurs (and triggers a
new SPF run) before the last SPF holdtimer has finished. The time between runs
may increase up to the max-holdtime value.This increase in holdtime prevents too
many SPF runs from occurring if multiple OSPF topology change events occur.
Examples To set the minimum delay time to 5 milliseconds and maximum delay time to 2
seconds, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
Related timers spf (IPv6 OSPF) (deprecated)
Commands
C613-50077-01 REV A
Parameter Description
<min-holdtime> Specifies the minimum delay between receiving a change to the
SPF calculation in milliseconds. The range is 0-2147483647. The
default SPF min-holdtime value is 50 milliseconds.
<max-holdtime> Specifies the maximum delay between receiving a change to the
SPF calculation in milliseconds. The range is 0-2147483647. The
default SPF max-holdtime value is 50 seconds.
configure terminal
router ipv6 ospf 100
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
timers spf exp 5 2000
927