Redistribute (Ipv6 Ripng) - Allied Telesis AT-AR3050S Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
(IP 6 RIP )
REDISTRIBUTE V NG

redistribute (IPv6 RIPng)

Overview Use this command to redistribute information from other routing protocols into
RIPng.
Use the no variant of this command to disable the specified redistribution. The
parameters metric and routemap may be used on this command, but have no
effect.
redistribute {connected|static|ospf} [metric <0-16>] [route-map
Syntax
<route-map>]
no redistribute {connected|static|ospf} [metric <0-16>]
[route-map <route-map>]
Default By default, the RIPng metric value is set to 1.
Mode Router Configuration
Example To redistribute information from other routing protocols into RIPng, use the
following commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
Related default-metric (IPv6 RIPng)
Commands
C613-50077-01 REV A
Parameter Description
<0-16>
Optional. Specifies the metric value to be used when
redistributing information. If a value is not specified, and no value
is specified using the
default is one.
<route-map>
Optional. Specifies route-map to be used to redistribute
information.
connected
Redistribute from connected routes.
static
Redistribute from static routes.
ospf
Redistribute from Open Shortest Path First (OSPF).
configure terminal
router ipv6 rip
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
default-metric (IPv6 RIPng)
redistribute static route-map mymap
redistribute static metric 8
command, the
725