Ip Ospf Resync-Timeout - Allied Telesis AT-AR3050S Command Reference Manual

OSPF C
OMMANDS
-
IP OSPF RESYNC TIMEOUT

ip ospf resync-timeout

Overview Use this command to set the interval after which adjacency is reset if out-of-band
resynchronization has not occurred. The interval period starts from the time a
restart signal is received from a neighbor.
Use the no variant of this command to return to the default.
Syntax ip ospf [<ip-address>] resync-timeout <1-65535>
no ip ospf [<ip-address>] resync-timeout
Mode Interface Configuration for a VLAN interface or a PPP interface.
Example The following example shows setting the OSPF resynchronization timeout value to
65 seconds on the VLAN interface vlan2.
awplus#
awplus(config)#
awplus(config-if)#
The following example shows setting the OSPF resynchronization timeout value to
65 seconds on the PPP interface ppp0.
awplus#
awplus(config)#
awplus(config-if)#
C613-50077-01 REV A
Parameter Description
<ip-address>
The IP address of the interface.
<1-65535>
Specifies the resynchronization timeout value of the interface in
seconds.
configure terminal
interface vlan2
configure terminal
interface ppp0
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
ip ospf resync-timeout 65
ip ospf resync-timeout 65
783