Wait - Allied Telesis AT-AR3050S Command Reference Manual

S C
CRIPTING OMMANDS

WAIT

wait
Overview This command pauses execution of the active script for the specified period of
time.
wait <delay>
Syntax
Default No wait delay is specified by default to pause script execution.
Mode Privileged Exec (when executed from a script not directly from the command line)
Usage Use this command to pause script execution in an . scp (AlliedWare Plus™ script) or
an . sh (ASH script) file executed by the
an
executed in the Privileged Exec mode.When a script is activated, the privilege level
is set to 1 enabling User Exec commands to run in the script. If you need to run
Privileged Exec commands in your script you need to add an
Exec mode)
Example See an example . scp script file extract below that will show port counters for
interface port1.0.1 over a 10 second interval:
Related activate
Commands
echo
enable (Privileged Exec mode)
C613-50077-01 REV A
Parameter Description
<delay>
<1-65335> Specify the time delay in seconds
enable (Privileged Exec mode)
command to the start of your script.
enable

show interface port1.0.1

wait 10

show interface port1.0.1
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
activate command. The script must contain
command since the wait command is only
enable (Privileged
358