Speed (Asyn) - Allied Telesis AT-AR3050S Command Reference Manual

S C M
YSTEM ONFIGURATION AND
( )
SPEED ASYN

speed (asyn)

Overview This command changes the console speed from the device. Note that a change in
console speed is applied for subsequent console sessions. Exit the current session
to enable the console speed change using the
speed <console-speed-in-bps>
Syntax
Default The default console speed baud rate is 9600 bps.
Mode Line Configuration
Usage This command is used to change the console (asyn) port speed. Set the console
speed to match the transmission rate of the device connected to the console (asyn)
port on your device.
Example To set the terminal console (asyn0) port speed from the device to 57600 bps, then
exit the session, use the commands:
awplus#
awplus(config)#
awplus(config-line)#
awplus(config-line)#
awplus(config)#
awplus#
Then log in again to enable the change:
awplus login:
Password:
awplus>
C613-50077-01 REV A
C
ONITORING OMMANDS
Parameter
<console-speed-in-bps>
1200
2400
9600
19200
38400
57600
115200
configure terminal
line console 0
exit
exit
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
clear line console
Description
Console speed Baud rate in bps (bits per second).
1200 Baud
2400 Baud
9600 Baud
19200 Baud
38400 Baud
57600 Baud
115200 Baud
speed 57600
exit
command.
278