Bgp Config-Type - Allied Telesis AT-AR3050S Command Reference Manual

Next-generation firewall
Hide thumbs Also See for AT-AR3050S:
Table of Contents

Advertisement

BGP
BGP4+ C
AND
OMMANDS
-
BGP CONFIG
TYPE

bgp config-type

Overview
Use this command to set the BGP configuration type to either standard or
enhanced types. When you configure the enhanced type, then BGP and BGP4+
communities are allowed to be sent and received by default. The enhanced type
is configured by default.
Use the no variant of this command to restore the default BGP configuration type
( enhanced).
bgp config-type {standard|enhanced}
Syntax
no bgp config-type
Default
By default, the BGP configuration type is enhanced.
Mode
Global Configuration
Usage
Note that the enhanced type default configuration may cause issues in some
networks if unauthorized BGP peers are advertising BGP communities to adjust
routing decisions.
Changing modes requires you to reload your device for the change to take effect:
When your device reloads, it will load with the standard BGP settings commonly
used by most vendors. Apply the standard type configuration if you have
interoperability issues.
To specify the standard BGP configuration type, enter the following commands:
Examples
awplus#
awplus(config)#
C613-50077-01 REV A
Parameter
Description
standard
Specifies the industry standard style configuration. After setting the
configuration to standard, make sure to use the
send-community
The
synchronization
Configuration mode and is shown in the configuration.
enhanced
Specifies the enhanced style configuration. The enhanced
configuration type requires no specific configuration for sending out
BGP standard community and extended community attributes. The
synchronization
Configuration mode and is not shown in configuration output.
awplus(config)#bgp config-type standard
awplus(config)#exit
awplus#reload
reboot system? (y/n): y
configure terminal
bgp config-type standard
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command to send out BGP community attributes.
command is enabled in the Global
command is enabled by default in the Global
neighbor
960

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents