Debug Platform Packet - Allied Telesis AT-AR3050S Command Reference Manual

S C
WITCHING OMMANDS

DEBUG PLATFORM PACKET

debug platform packet
Overview This command enables platform to CPU level packet debug functionality on the
device.
Use the no variant of this command to disable platform to CPU level packet debug.
If the result means both send and receive packet debug are disabled, then any
active timeout will be canceled.
debug platform packet [recv] [send] [timeout <timeout>] [vlan
Syntax
<vlan-id>|all]
no debug platform packet [recv] [send]
Default A 5 minute timeout is configured by default if no other timeout duration is
specified.
Mode Privileged Exec and Global Configuration
Usage This command can be used to trace packets sent and received by the CPU. If a
timeout is not specified, then a default 5 minute timeout will be applied.
If a timeout of 0 is specified, packet debug will be generated until the no variant of
this command is used or another timeout value is specified. The timeout value
applies to both send and receive debug and is updated whenever the debug
platform packet command is used.
Examples To enable both receive and send packet debug for the default timeout of 5
minutes, enter:
awplus#
To enable receive packet debug for 10 seconds, enter:
awplus#
To enable send packet debug with no timeout, enter:
awplus#
C613-50077-01 REV A
Parameter Description
recv
Debug packets received.
send
Debug packets sent.
timeout
Stop debug after a specified time.
<timeout>
<0-3600>The timeout period, specified in seconds.
vlan
Limit debug to a single VLAN ID specified.
<vlan-id>
<1-4094> The VLAN ID to limit the debug output on.
all
Debug all VLANs (default setting).
debug platform packet
debug platform packet recv timeout 10
debug platform packet send timeout 0
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
394