Area Default-Cost - Allied Telesis AT-AR3050S Command Reference Manual

OSPF C
OMMANDS
-
AREA DEFAULT COST

area default-cost

Overview This command specifies a cost for the default summary route sent into a stub or
NSSA area.
The no variant of this command removes the assigned default-route cost.
Syntax area <area-id> default-cost <0-16777215>
no area <area-id> default-cost
Mode Router Configuration
Usage The default-cost option provides the metric for the summary default route,
generated by the area border router, into the NSSA or stub area. Use this option
only on an area border router that is attached to the NSSA or stub area. Refer to the
RFC 3101 for information on NSSA.
Example To set the default cost to 10 in area 1 for the OSPF instance 100, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
Related area nssa
Commands
area stub
C613-50077-01 REV A
Parameter Description
<area-id>
The OSPF area that you are specifying the default summary route
cost for. Use one of the following formats: This can be entered in
either dotted decimal format or normal decimal format.
<ip-addr>
<0-4294967295>
For example the values dotted decimal 0.0.1.2 and decimal 258
would both define the same area ID.
default-cost Indicates the cost for the default summary route used for a stub or
NSSA area.
Default: 1
configure terminal
router ospf 100
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
OSPF Area ID expressed in IPv4 address
format A.B.C.D.
OSPF Area ID expressed as a decimal number
within the range shown.
area 1 default-cost 10
738