Aggregate-Address (Ipv6 Ripng) - Allied Telesis AT-AR3050S Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
- (IP 6 RIP
AGGREGATE ADDRESS V

aggregate-address (IPv6 RIPng)

Overview Use this command to add an aggregate route to RIPng.
Use the no variant of this command to remove the aggregate route from RIPng.
Syntax aggregate-address <ipv6-addr/prefix-length>
no aggregate-address <ipv6-addr/prefix-length>
Mode Router Configuration
Usage The route will not be added to the RIPng database unless the database contains at
least one route which is contained within the address range covered by the
aggregate route. As soon as there are any such component routes in the RIPng
database, then the following occurs:
•
•
Note that simply having a component route in the IPv6 route database is not a
sufficient condition for the aggregate route to be included into the RIPng
database. The component route(s) must be in the RIPng database before the
aggregate route will be included in the RIPng database. There is no restriction on
the method by which the component routes have arrived into the RIPng database,
it can be by being connected RIP interfaces, by redistribution or by direct inclusion
using the route command in router IPv6 RIP configuration mode.
awplus#
Example
awplus(config)#
awplus(config-router)#
C613-50077-01 REV A
)
NG
Parameter
<ipv6-addr/prefix-length>
the aggregate route is added to the RIPng database
all the component routes that are within the address range covered by the
aggregate route are retained in the RIPng database, but are marked as
suppressed routes. The aggregate route will be advertised in RIPng updates,
and the component route will no longer be advertised.
configure terminal
router ipv6 rip
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Specify the IPv6 Address in the format X:X::X:X/
Prefix-Length. The prefix-length is a decimal
integer between 1 and 128.
aggregate-address 2001:db8::/32
711