Ipv6 Tftp Source-Interface - Allied Telesis AT-AR3050S Command Reference Manual

F M C
ILE ANAGEMENT OMMANDS
6 -
IPV TFTP SOURCE INTERFACE

ipv6 tftp source-interface

Overview Use this command to manually specify the IPv6 address that all TFTP requests
originate from. This is useful in network configurations where TFTP servers only
accept requests from certain devices, or where the server cannot dynamically
determine the source of the request.
Use the no variant of this command to stop specifying a source.
ipv6 tftp source-interface [<interface>|<ipv6-add>]
Syntax
no ipv6 tftp source-interface
Default There is no default source specified.
Mode Global Configuration
Usage This command is helpful in network configurations where TFTP traffic needs to
traverse point-to-point links or subnets within your network, and you do not want
to propagate those point-to-point links through your routing tables.
In those circumstances, the TFTP server cannot dynamically determine the source
of the TFTP request, and therefore cannot send the requested data to the correct
device. Specifying a source interface or address enables the TFTP server to send the
data correctly.
Example To specify that TFTP requests originate from the IPv6 address 2001:db8::8a2e:7334,
use the following commands:
awplus#
awplus(config)#
Related copy (filename)
Commands
C613-50077-01 REV A
Parameter Description
<interface>
The interface that TFTP requests originate from. The device will
use the IPv6 address of this interface as its source IPv6 address.
You can specify any interface that can have an IPv6 address
attached to it (e.g. a VLAN or an Eth interface).
<ipv6-add>
The IPv6 address that TFTP requests originate from, in the format
x:x::x:x, for example, 2001:db8::8a2e:7334.
configure terminal
ipv6 tftp source-interface 2001:db8::8a2e:7334
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
124