Ip Rip Authentication String - Allied Telesis AT-AR3050S Command Reference Manual

RIP C
OMMANDS

IP RIP AUTHENTICATION STRING

ip rip authentication string
Overview Use this command to specify the authentication string or password used by a key.
Use the no variant of this command to remove the authentication string.
Syntax ip rip authentication string <auth-string>
no ip rip authentication string
Mode Interface Configuration for a VLAN interface or a PPP interface.
Usage The AlliedWare Plus™ implementation provides the choice of configuring
authentication for single key or multiple keys at different times. Use this command
to specify the password for a single key on an interface. Use the
authentication key-chain
information about configuring RIP, see the
Configuration
Use the following steps to configure a route to enable RIPv2 authentication using
a single key or password:
1)
2)
awplus(config-if)#
See the example below to specify mykey as the authentication string with MD5
Example
authentication for the VLAN interface vlan2:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50077-01 REV A
Parameter Description
<auth-string>
The authentication string or password used by a key. It is an alpha-
numeric string and can include spaces.
Guide.
Define the authentication string or password used by the key for the desired
interface, using the following commands:
awplus# configure terminal
awplus(config)#
Specify the mode of authentication for the given interface (text or MD5),
using the following commands:
awplus# configure terminal
awplus(config-if)#
<auth-string>
awplus(config)#
configure terminal
interface vlan2
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command for multiple keys authentication. For
RIP Feature Overview and
interface <id>
ip rip authentication string
interface <id>
ip rip authentication mode {md5|text}
ip rip authentication string mykey
ip rip authentication mode md5
ip rip
674