Length (Asyn) - Allied Telesis AT-AR3050S Command Reference Manual

U A C
SER CCESS OMMANDS
( )
LENGTH ASYN

length (asyn)

Overview Use this command to specify the number of rows of output that the device will
display before pausing, for the console or VTY line that you are configuring.
The no variant of this command restores the length of a line (terminal session)
attached to a console port or to a VTY to its default length of 22 rows.
Syntax length <0-512>
no length
Mode Line Configuration
Default The length of a terminal session is 22 rows. The no length command restores the
default.
Usage If the output from a command is longer than the length of the line the output will
be paused and the '–More–' prompt allows you to move to the next screen full of
data.
A length of 0 will turn off pausing and data will be displayed to the console as long
as there is data to display.
Examples To set the terminal session length on the console to 10 rows, use the command:
awplus#
awplus(config)#
awplus(config-line)#
To reset the terminal session length on the console to the default (22 rows), use the
command:
awplus#
awplus(config)#
awplus(config-line)#
To display output to the console continuously, use the command:
awplus#
awplus(config)#
awplus(config-line)#
Related terminal resize
Commands
terminal length
C613-50077-01 REV A
Parameter Description
<0-512>
Number of lines on screen. Specify 0 for no pausing.
configure terminal
line console 0
configure terminal
line console 0
configure terminal
line console 0
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
length 10
no length
length 0
190